Dell DL4300 Owner's Manual page 49

Option Description
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Port J Sets the drive type of the selected device. For Embedded SATA settings in ATA
mode, set this field to Auto to enable BIOS support. Set it to OFF to turn off BIOS
support.
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Integrated Devices
You can use the Integrated Devices screen to view and configure the settings of all integrated devices
including the video controller, integrated RAID controller, and the USB ports.
Viewing Integrated Devices
To view the Integrated Devices screen, perform the following steps:
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish
booting, and then restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Integrated Devices.
Integrated Devices details
The Integrated Devices screen details are explained as follows:
Option Description
USB 3.0 Setting Enables or disables the USB 3.0 support. Enable this option only if your operating
system supports USB 3.0. If you disable this option, devices operate at USB 2.0
speed. USB 3.0 is enabled by default.
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacity of the hard drive. This field is
undefined for removable media devices such as optical
drives.
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacity of the hard drive. This field is
undefined for removable media devices such as optical
drives.
49