Removing A Hard Drive From A Hard Drive Carrier; Installing A Hard Drive Into A Hard Drive Carrier - Dell DL4300 Owner's Manual

Removing a hard drive from a hard drive carrier

Prerequisites
1. Keep the Phillips #1 screwdriver ready.
2. Remove the hot swappable hard drive carrier from the system.
Steps
1. Remove the screws from the slide rails on the hard drive carrier.
2. Lift the hard drive out of the hard drive carrier.
Figure 73. Removing a hard drive into a hard drive carrier
1. screw (4)
3. hard drive carrier
Related video
http://www.Dell.com/QRL/Server/PER730/HDD

Installing a hard drive into a hard drive carrier

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1. Insert the hard drive into the hard drive carrier with the connector end of the hard drive toward the
back of the carrier.
2. Align the screw holes on the hard drive with the screws holes on the hard drive carrier.
When aligned correctly, the back of the hard drive is flush with the back of the hard drive carrier.
3. Attach the screws to secure the hard drive to the hard drive carrier.
2. hard drive
139