Front Bumper Installation; Brush Guard Assembly And Installation - Yerf-Dog Retriever 4x2 Owner's Manual

FRONT BUMPER INSTALLATION

Insert all bolts and nuts before tightening.
Attach Front Bumper at top left and top right using
Bolts (#02), Washers (#03) and Locknuts (#04).
Attach to frame at bottom center using Bolts (#05).

BRUSH GUARD ASSEMBLY AND INSTALLATION

BRUSH GUARD COMPONENTS
DRIVER SIDE REAR
Brush Guard Brush Guard
05608
05609
NOTE: Do not tighten Bolts or Nuts until
all pieces of the brush guard are assembled.
Loosen nut on stud as needed to aid in
assembly.
CAUTION
The Brush Guard Components are not
designed or intended to serve as a Roll Over
Protective Structure and should not be relied
upon to protect the occupants in the event
of a vehicle rollover. To prevent severe
personal injury or death from vehicle rollover,
follow the warnings and instructions in this
manual and in the decals on the vehicle itself.
Yerf-Dog Retriever CUV Owners Manual
Model# 34851 • Revision C - 2/05
PASSENGER SIDE
Brush Guard
05610
www.yerf-dog.com
For questions in USA, 888-926-6554
FRONT BUMPER HARDWARE
#02 - (2) 3/8" x 2" Bolts
#03 - (2) 3/8" Flat Washers
#04 - (2) 3/8" Lock Nuts
#05 - (2) 3/8" x 1-1/4" Bolts
BRUSH GUARD HARDWARE
#06 - (2) Rubber Grommets
#07 - (12) 3/8" x 3-1/2" Bolts
#08 - (14) 3/8" Flat Washers
#09 - (8) 3/8" Lock Nuts
#10 - (2) 3/8" Studs
LUMBAR SEAT PAD / HEADREST HARDWARE
(14) Machine Screws
02280
06166
06883
Page 35
Manual# 06367