Bed Latch - Yerf-Dog Retriever 4x2 Owner's Manual

STOPPING THE VEHICLE
To stop the vehicle, release the accelerator pedal and depress the brake pedal until the vehicle comes
to a complete stop.
WARNING
• Driving through water may affect the brakes. After driving through water, check
effectiveness of the brakes by gently depressing the brake pedal. If the vehicle does not
slow down at the normal rate, continue to depress the brake pedal until the brakes dry
out and normal performance returns.
CAUTION
• When stopped on a hill, use the brake pedal to hold your position. Do not use the
accelerator pedal.
PARKING AND LEAVING THE VEHICLE
1. After stopping the vehicle, always fully engage the parking brake. Make sure it is fully engaged.
This will prevent the vehicle from rolling (see page 13).
2. Turn the key switch counterclockwise until the key is vertical and place the Forward/Reverse
handle in the NEUTRAL position and remove the key.
3. If parking vehicle on unlevel ground, we recommend using wheel chocks for added safety.

BED LATCH

Read DANGER and WARNING on page 7.
The vehicle is equipped with a bed latch on the driver side of the vehicle (Figure 9) and an automatically
engaging prop rod (Figure 10). To lift the bed, pull the latch handle upward and lift the bed. To close
the bed, disengage the prop rod and gently lower the bed until the bed latch engages. DO NOT drop
the bed. See following WARNING and NOTE.
WARNING
• Keep hands and all body parts as well as other objects clear of crush area between
raised cargo bed, prop rod assembly and seat back support. Failure to do so could result
in severe injury or death.
NOTE: The vehicle is equipped with an automatically engaging prop rod. Never tamper with or alter
prop rod assembly or operation.
Figure 9
Page 18
Manual# 06367
Bed Latch
www.yerf-dog.com
For questions in USA, 888-926-6554
Figure 10 Prop Rod
Yerf-Dog Retriever CUV Owners Manual
Model# 34851 • Revision C - 2/05