Bridge-Mono 16/8 Mode; Bridge-Mono 100V Mode - Crown CTs 1200 Operation Manual

Cts series 2-channel models multi-channel models
Hide thumbs Also See for CTs 1200:
Table of Contents

Advertisement

CTs Power Amplifi ers
3 Setup

3.6.3 Bridge-Mono 16/8 Mode

CAUTION: Never change the position of
the Mode Switch while the amplifi er
power is on. See Section 5.2.2 for more
information.
Typical input and output wiring, along with level
control and Mode Switch settings are shown in
Figure 3.8. Make sure the Mode switch is set to
the "Bridge 16/8" position.
INPUTS: Connect input wiring only to the lower-
(odd-) numbered channel pair.
OUTPUTS: Connect the speaker across the
posi tive terminals of each channel pair. Do not
use the negative terminals of the channel pair
when the pair is being operated in Bridge-Mono
mode.
NOTE: When operating the channel pair in
Bridge-Mono mode, turn down (full CCW) the
level control for the higher (even)-numbered
channel of the channel pair. The lower (odd)-
numbered level control works both channels.

3.6.4 Bridge-Mono 100V Mode

CAUTION: Never change the position of
the Mode Switch while the amplifi er
power is on. See Section 5.2.2 for more
information.
Typical input and output wiring, along with level
control and Mode Switch settings are shown in
Figure 3.9. Make sure the Mode switch is set to
the "Bridge 100V" position.
INPUTS: Connect input wiring only to the lower-
(odd-) numbered channel pair.
OUTPUTS: Connect the speaker across the
posi tive terminals of each channel pair. Do not
use the negative terminals of the channel pair
when the pair is being operated in Bridge-Mono
mode.
NOTE: When operating the channel pair in
Bridge-Mono mode, turn down (full CCW) the
level control for the higher (even)-numbered
channel of the channel pair. The lower (odd)-
numbered level control works both channels.
Operation Manual
BRIDGE
DUAL
DUAL
CH 2
CH 1
CH 4
CH 3
DUAL
DUAL
BRIDGE
Figure 3.8 System Wiring and Control Settings, Bridge-Mono Mode, 16/8 Ohm.
100V
BRIDGE
DUAL
DUAL
CH 2
CH 1
CH 4
CH 3
DUAL
DUAL
BRIDGE
Figure 3.9 System Wiring and Control Settings, Bridge-Mono Mode, 100V
See the Crown
Amplifi er Appli cation
Guide, available
online at www.
crownaudio.com, for
pin assignments for
commonly used
connector types.
page 37

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents