Pulse Grip Feature; Calorie Display - Spirit XT285 Owner's Manual

Hide thumbs Also See for XT285:

Table of Contents

1/4 Mile T rack

segment indicates your progress. Once the 1/4-mile (Metric - 0.4k) is complete this feature will

begin again. There is a lap counter in the message window for monitoring your distance.

Pulse Grip Feature

The Pulse (Heart Rate) console window will display your current heart rate in beats per minute

during the workout. You must use both stainless steel sensors on the front cross bar or the heart

rate transmitter chest strap to display your pulse. Pulse value displays anytime the upper display is

receiving a Pulse signal. You may not use the Grip Pulse feature while in Heart Rate Programs.

Note: Refer to Important Safety Instructions (page 2) concerning Pulse Grip operation.

Displays the cumulative calories burned at any given time during your workout.

Note: This is only a rough guide used for comparison of different exercise sessions, which cannot be used for

medical purposes.

Speakers

The console has built-in Speakers. You may plug an Audio Source (CD player, MP3, Computer,

etc.) into the Jack on the right side of console. There is no volume control on the console. The

volume must be controlled on the Audio Source.

Handrail Buttons Disable Switch

To the right of the Stop button there is a Handrail control switch and an indicator light next to

it When the indicator light is lit, the handrail switches are disabled. This allows you to use the full

length of the handrails without fear of activating the speed or elevation controls.

T o T urn T readmill Off

1. Display will automatically turn off (go to sleep) after 30 minutes (no key operations). The

treadmill will draw very little current in sleep mode (about as much as your television

when it is turned off).

2. Remove the Safety Key tether cord.

3. Turn off the main switch on the front of the treadmill, below the motor cover.

ATTENTION

powered on unless the main power switch is turned off. To exit the display mode, for normal operation, press and

hold the Stop, Enter and Handrail Control Key

Use any of the Program, Incline or Speed + keys to change the setting to Off then press Enter.

XT285

T readmill

Table of Contents