Table of Contents
Advertisement
4
Use the CH1 SELECT switch to select the
input signal to be recorded to audio channel 1.
INT (L):
Audio from the built-in microphone Lch is
recorded to audio channel 1.
INPUT 1:
Audio from a device connected to INPUT 1
terminal is recorded to channel 1.
INPUT 2:
Audio from a device connected to INPUT
terminal is recorded to channel 1.
5
Use the CH2 SELECT switch to select the
input signal to be recorded to audio channel 2.
INT (R):
Audio from the built-in microphone Rch is
recorded to audio channel .
INPUT 2:
Audio from a device connected to INPUT
terminal is recorded to channel .
•
When inputting the microphone signal to
channels 1 and , connect the microphone to
INPUT and switch both CH1 SELECT and
CH SELECT to INPUT .
Adjusting the recording level
AUDIO control knobs
Use the AUDIO control knobs to adjust the
recording level of the built-in microphone or of
audio signals input through the INPUT 1/ (XLR
3-pin) terminals.
To adjust the volume of the sound for monitoring.
(Page 6)
To adjust the recording level of the audio signals,
turn the AUDIO control knobs while referring to
the audio level meter at the bottom left of the
viewfinder and LCD monitor, regardless of the MIC
ALC option setting (Page 93) on the RECORDING
SETUP screen of the setting menu.
•
Check the recording volume level prior to
shooting.
•
The recording level of this camera is set
approximately dB higher than Panasonic
broadcasting camera recorders (AJ series
products).
51
Advertisement
Table of Contents
