Bostitch DA1564K Operation And Maintenance Manual page 14

MAINTENANCE CHECKLIST
Maintenance
Inspect trigger performance
Drain condensation from air
compressor tanks and air filters
(if present)
Clean magazine assembly
Clean nose assembly
Ensure all fasteners remain
tight
Check/clean air inlet air filter
Replace no-mar tip
Replace swivel air fitting
Replace piston/driver assembly Maintains consistent drive
Replace O-rings
Replace bumper
Replace headvalve
Replace engine cylinder
Benefit
Ensure trigger system is in
proper working order
Prevents accumlation of
moisture that can impede tool
performace
Prevents accumlation of debris
that could cause a jam
Prevents accumlation of debris
that could cause a jam
Prevent loose parts
Maintains proper air flow to
engine for peak performance.
Prevents marks in softwood
applications
Maintains proper air flow to
engine for peak performance
quality
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance
Maintains engine for peak
performance
Procedure
Refer to Tool Operation Check
section in this manual
Open drain cock on tanks and
air filters and drain all
condensate
Blow clean with compressed air Daily
Blow clean with compressed air Daily
Tighten all fasteners with
appropriately sized hex wrench
Remove end cap and use
compressed air blow gun to
blow filter clean. Replace filter
as required.
Remove worn no-mar tip and
replace with a new tip (a spare tip is
located on the magazine)
Remove worn swivel air fitting
and replace with new swivel
fitting
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
Refer to replacement part kit
instructions
-14-
Service Interval
Daily
Daily
Weekly
25,000 Fasteners, or monthly -
if used in dusty location
25,000 Fasteners
50,000 Fasteners
250,000 Fasteners
250,000 Fasteners
250,000 Fasteners
250,000 Fasteners
500,000 Fasteners