Advertisement
CONTROL MODULE: Locate the module under dash as high as possible, away from moving parts. Driver's
Side usually provides an easy location for the majority of the wiring connections.
WARNING:
Module isn't water proof.
If the module gets water damaged, the vehicle windows could stop working.
8 Position Connector Plug
1 - GRAY: Negative roll trigger for Circuit #1 and #2.
Circuit #1 and #2 are controlled by LOOP 1 - USE ONLY ONE.
2 - GRAY/WHITE: Positive roll trigger for Circuit #1 and #2.
3 - BLACK: SYSTEM CHASSIS GROUND: This wire must be connected to chassis metal of vehicle.
Scrape away any paint or dirt from the connection point to ensure a good connection.
4 - GREEN: (-) 300 milliamps Negative output though out operation of any 4 circuits
5 - YELLOW: (+) 300 milliamps Positive output through out operation of any 4 circuits
6 - BLUE: Negative roll trigger for Circuit #3 and #4.
Circuit #3 and #4 are controlled by LOOP 2 - USE ONLY ONE.
7 - BLUE/RED: Positive roll trigger for Circuit #3 and #4.
8 - PINK: Connect to an ignition wire that shows +12 Volts when the key in both "On" and "Start" positions.
This wire prevents the module from activating the windows while driving the vehicle.
COMPONENT MOUNTING
Don't Install CS-5601 Module inside vehicle door
WIRING
– Small Wires
3
.
Advertisement
