Download Print this page

CrimeStopper CS-2000 Installation & Operating Instructions Manual page 4

Remote control alarm system

Advertisement

YELLOW WIRE: IGNITION SWITCHED "ON" AND "START" +12 VOLTS
Connect to an ignition wire (or fuse in the fuse box) that shows +12 Volts when the key in both "On" and "Start"
positions.
BLACK WIRE: SYSTEM CHASSIS GROUND
THIS WIRE MUST BE CONNECTED TO CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt from
the connection point to ensure a good connection. We recommend the kick panel area for your ground point.
VIOLET WIRE: (+) DOOR TRIGGER INPUT
Same as GREEN wire below except this wire is used for vehicles that show a positive voltage (12 volts) when the door
is open such as Ford.
GREEN WIRE: (-) DOOR TRIGGER INPUT
Identify the wire that reads Ground when any door is open and 12 volts when all doors are closed.
2 PIN PLUG (BLUE): PROGRAM/OVERRIDE PUSH BUTTON
p
2 PIN PLUG (RED): LED INDICATOR (RED FLASHING LIGHT)
4 PIN SENSOR PLUG:
WHITE WIRE:
NEG. WARN AWAY
BLUE WIRE:
NEG. TRIGGER
BLACK WIRE:
SENSOR GROUND
RED WIRE:
SENSOR +12V POWER
PROGRAMMABLE OPTIONS
1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear a long confirmation chirp.
2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to
the feature list below. The siren will chirp for each button press.
3. When you get to the desired option number, press button the appropriate button on the transmitter change the
option according to the chart below. Button #1 gives a single light flash/siren chirp and Button #2 gives two light
flashes/siren chirps. See chart Below for Option descriptions and vales.
4. Change ONE option at a time repeating steps 1-3 as needed. When you are finished customizing options, check
operation to see if the option(s) have changed.
Option # Description
PROGRAMMING
1
Passive Arming
2
Autolock with Ignition
WIRING
*The Sensor supplied with the system does not require
any additional wiring, simply mount the sensor in a
suitable location, plug in, and adjust sensitivity.
Button #1 (Large)
OFF (Default)
ON (Default)
Button #2 (Small)
ON
OFF

Advertisement

loading