Advertisement
WIRING
RED WIRE: +12V POWER INPUT (15 Amp fuse)
Connect to +12 Volt source with supplied fuse & holder. Recommended location for this connection is at the vehicle
battery positive terminal.
WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT (10 Amp Max.)
Connect to switched parking light wire at back of light switch. If this is not possible, connect directly to one of the
parking lights at the front of the vehicle. European vehicles require separate right and left circuits. Use a dual relay or
2 diodes to separate the output signal.
BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)
Connect to RED siren wire.
BLUE/WHITE WIRE: (-) NEG. DOOR LOCK OUTPUT
Connects to lock circuit of NEGATIVE door lock systems or to terminal 85 of a relay. See Door Lock diagrams.
WHITE/RED WIRE: (-) NEG. DOOR UNLOCK OUTPUT
Connects to unlock circuit of NEGATIVE door lock systems or to terminal 85 of a relay. See Door Lock diagrams.
ORANGE WIRE: (-) NEG. ARMED OUTPUT / STARTER DISABLE (500mA Neg.)
Ground output when system is armed. This output is used for disabling the starter or to activate other devices such as
scanner LED's, window modules, voice modules etc. For starter kill, cut starter wire and connect between 87A and 30
on relay. Connect orange wire to 85 and connect 86 to an Ignition source that has voltage in the ON and CRANKING
position.
BROWN/WHITE WIRE: (-) HORN HONK OUTPUT (Optional, May Require Relay)
This wire provides a pulsed (-) negative output for honking the vehicle's horn when the system is tripped or when panic
is activated. Connect this wire to Negative Horn trigger wire in the steering column or to a relay on vehicles with a
positive horn circuit.
BLACK/WHITE WIRE: (-) DOME LIGHT ILLUMINATION (Optional, May Require Relay)
Connect to terminal 85 of relay. Connect terminal 86 to constant. Connect terminal 87 to +12V constant or ground
depending on the type of dome light circuit in the vehicle. 30 to the dome light circuit.
BLUE WIRE: (-) HOOD/TRUNK INPUT
This wire is an input trigger for a grounding hood or trunk pin switch. Connect to existing hood and trunk pin switches
that read ground when open. If no existing switches are available, install new pin switches. Note: DO NOT mount new
pin switches in water pathways.
GRAY WIRE: (-) AUX REMOTE OUTPUT 1 (Optional, May Require Relay)
Connects to terminal 85 of a relay. Connect terminal 86 to constant. Connect terminal 87 to +12V constant or ground
depending on the type of circuit that needs to be activated. Connect terminal 30 to the device/circuit to be activated.
Advertisement
