Table of Contents
Advertisement
Default Switch Parameters
Configuration Parameter
P130 IP address
Default gateway
VLANs
Spanning tree
Bridge priority for Spanning Tree
NTP server IP address
Timezone offset
Read-only SNMP community string
Read-write SNMP community string
Trap SNMP community string
SNMP retries number
SNMP timeout
SNMP authentication trap
CLI timeout
Default Port Parameters
Configuration Parameter
Duplex Mode
Speed Mode
Flow Control
Flow Control Advertisement
Autonegotiation
Administration State
Port VLAN ID
Tagging Mode
Port Priority
Spanning Tree Cost
Spanning Tree Port Priority
Default Setting
149.49.32.134
0.0.0.0
VLAN 1
Enabled
32768
0.0.0.0
0 hours
Public
Public
Public
3
2000 Seconds
Disabled
15 Minutes
Default Setting
• 10/100BaseTX ports: Half duplex
• 100BaseFX ports/1000BaseF ports: Full duplex
• 10/100BaseTX ports: 10 M
• 100BaseFX ports: 100 M
• 1000BaseF ports: 1000M
• Off
• 1000BaseF ports: Off
• 10/100BaseTX ports/1000BaseF ports: Enabled
• 100BaseFX ports: Not applicable
Enabled
1
Clear
0
• 10/100BaseTX ports : 100
• 100BaseFX ports: 20
• 1000BaseF ports: 4
80 Hex
5
Advertisement
Table of Contents
