Table of Contents
Advertisement
Crestron TPS-4500IMW
Balanced Using Twisted Pair Cable
Installation into the Electrical Box
The TPS-4500IMW mounts into a 1-gang electrical box (recommended
2.5" depth). Verify that the unit is installed into the electrical box as
shown after this paragraph. Use the orientation of the RJ45 connector as
a guide. Secure the TPS-4500IMW to the electrical box with the two #6-
32 flat head slotted screws (1-inch length), supplied.
Installation of the TPS-4500IMW
Once the TPS-4500IMW is installed into a 1-gang electrical box, it can
be covered with a decora wallplate, purchased separately. Crestron
recommends Leviton, part number 80401-* (where * denotes an
abbreviation that represents color). Refer to the list after this paragraph
for available colors at the time of this printing.
Operations Guide - DOC. 5913
COMP
CONNECT TO
Y
COMP Y FOR
COMPOSITE
VIDEO OR
LUMINANCE
COMPONENT
OF S-VIDEO.
Wall-Mounted Interface Module
75 Ohm
INPUT +
INPUT -
GROUND
C
CRESTRON
TPS-4500IMW
Wall-Mounted Interface Module: TPS-4500IMW • 7
JUMPERS REMOVED.
INPUT IMPEDANCE
EQUALS 100 OHMS.
CONNECT
TO C FOR
CHROMINANCE
COMPONENT
OF S-VIDEO.
Advertisement
Table of Contents
