Table of Contents
Advertisement
Wall-Mounted Interface Module
been installed into the touchpanel and a video window object resides on a
page within the uploaded VisionTools™ Pro-e project.
Hardware Hookup Connections to the Back of the TPS-4500IMW
CONNECT
TO VIDEO
SOURCE*
CONNECT
TO CNX
GENERATION
CONTROL
SYSTEM
OR CRESNET
PERIPHERALS
NOTE: If there is no video source, do not make connections to either
NTSC/PAL video connector. However, leave connector and jumpers
attached to the NTSC/PAL video four-pin connector on the TPS-
4500IMW.
NOTE: Video balance is determined by external connections. Refer to
the two diagrams that follow this note.
Unbalanced Using Coaxial Cable
6 • Wall-Mounted Interface Module: TPS-4500IMW
75 Ohm
INPUT +
INPUT -
GROUND
COMP
Y
CRESTRON
TPS-4500IMW
NET
24 Y
Z G
COMP
CONNECT TO
COMP Y FOR
COMPOSITE
VIDEO OR
LUMINANCE
COMPONENT
OF S-VIDEO.
CONNECT
TO VIDEO
SOURCE*
C
* CONNECTION TO A VIDEO SOURCE IS ONLY
NECESSARY IF THE TPS-VID EXPANSION
CARD IS INSTALLED INTO THE TOUCHPANEL.
POSSIBLE CONNECTION OPTIONS ARE:
DEPENDING ON THE OPTION, THE TWO
JUMPERS ON THE NTSC/PAL VIDEO
FOUR-PIN CONNECTOR REMAIN
ATTACHED (AS SHOWN) OR ARE
75 Ohm
INPUT +
INPUT -
GROUND
C
Y
CRESTRON
TPS-4500IMW
Crestron TPS-4500IMW
- NO CONNECTION
- UNBALANCED VIDEO
(USING COAXIAL CABLE)
- BALANCED VIDEO
(USING TWISTED PAIR CABLE)
REMOVED.
JUMPERS REMAIN
IN PLACE.
INPUT IMPEDANCE
EQUALS 75 OHMS.
CONNECT
TO C FOR
CHROMINANCE
COMPONENT
OF S-VIDEO.
Operations Guide - DOC. 5913
Advertisement
Table of Contents
