IBM IntelliStation A Pro Type 6217 User Manual page 59

For more information about HostRAID, see "Using the Adaptec HostRAID
configuration programs" on page 25.
v The electromagnetic interference (EMI) integrity and cooling of the computer are
protected by having all bays and PCI-X slots covered or occupied. When you
install a drive or PCI-X adapter, save the EMC shield and filler panel from the
bay or the PCI-X adapter slot cover in the event you later remove the drive or
adapter.
v For a complete list of supported options for your computer, go to
http://www.ibm.com/pc/; then, select your country and navigate to the list of
options for your computer.
Installing a drive in bay 2
To install a drive in bay 2, complete the following steps:
1. Read the safety information beginning on page v, the guidelines in "Handling
static-sensitive devices" on page 34, and the documentation that comes with
your drive.
2. Make sure that you have all the cables and other equipment that is specified in
the documentation that comes with the drive.
3. Check the instructions that come with the drive to determine whether you must
set any switches or jumpers on the drive. If you are installing a SCSI device,
make sure that you set the SCSI ID for that device.
4. Turn off the computer and all attached devices; then, disconnect all external
cables and power cords.
5. Remove the side cover (see "Removing the side cover" on page 39).
6. Remove the front bezel (see "Removing the bezel" on page 41).
7. Remove the support bracket (see "Removing and installing the support
bracket" on page 40).
8. Use a screwdriver to pry the filler panel and EMC shield away from the
computer.
Note: If you are installing a drive that contains a laser, review the following
safety precaution.
EMC shield
Filler panel
Chapter 4. Installing options
47