Handling Static-Sensitive Devices - IBM IntelliStation A Pro Type 6217 User Manual

Handling static-sensitive devices

Attention:
avoid damage, keep static-sensitive devices in their static-protective packages until
you are ready to install them.
Notes:
1. If you are instructed to return a device or component, follow all packaging
2. Use product-specific electrostatic-discharge procedures when they exceed the
3. Make sure that the electrostatic-discharge-protective devices you use have been
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v Limit your movement. Movement can cause static electricity to build up around
v Wear an electrostatic-discharge wrist strap, if one is available.
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the computer
v Take additional care when handling devices during cold weather. Heating reduces
v Select a grounding system that meets the specific service requirement. Use of a
34
IntelliStation A Pro Type 6217: User's Guide
Static electricity can damage electronic devices, and your computer. To
instructions. Use any packaging materials for shipping that are supplied to you.
requirements provided here.
certified (ISO 9000) as fully effective.
you.
metal part of the computer for at least 2 seconds. This drains static electricity
from the package and from your body.
without setting down the device. If it is necessary to set down the device, put it
back into its static-protective package. Do not place the device on your computer
cover or on a metal surface.
indoor humidity and increases static electricity.
grounding system is recommended but is not required.
– Attach the electrostatic-discharge ground clip to any frame ground, ground
braid, or green-wire ground.
– Use an electrostatic-discharge common ground or reference point when
working on double-insulated or battery-operated devices. You can use coax or
connector-outside shells on these devices.
– Use the round ground-prong of the ac plug on ac-operated devices.