Crestron QM-TX Operation Manual page 30

QuickMedia™ Transmitter
26 • QuickMedia™ Transmitter: QM-TX
2. Open Installer's Toolbox and click Tools | Manage Address Book to
display the communications settings. Enter the new address name, and
then click RS-232 as the connection type.
3. The PC communication settings specified here should match the
protocol that the control processor expects. The usual settings are as
follows:
•
Port = COM 1 through COM 8. Select the correct COM port on the
PC.
•
Baud rate = 115200.
•
Parity = None.
•
Number of data bits = 8.
•
Number of stop bits = 1.
•
Hardware handshaking (RTS/CTS) enabled.
•
Software handshaking (XON/XOFF) not enabled.
"Address Book" Window – Serial Settings
4. After setting the correct parameters, click OK to return to the
Installer's Toolbox main window.
5. Click Tools | Network Device Tree to display the devices in the
system.
TCPIP Connection
1. Ensure that all devices are connected to the control processor. For
TCP/IP, use CAT5 straight through cables with 8-pin RJ-45 connectors
to connect the LAN port on the control processor and the LAN port on
the PC to the Ethernet hub. Alternatively, you can use a CAT5
crossover cable to connect the two LAN ports directly, without using a
hub. The following table illustrates pinouts for straight through and
crossover RJ-45 cables. Pins 4, 5, 7, and 8 are not used.
Crestron QM-TX
Operations Guide - DOC. 6334