Industry Compliance - Crestron QM-TX Operation Manual

QuickMedia™ Transmitter
Q M
8
1
8 • QuickMedia™ Transmitter: QM-TX
QM (Output)
The 8-pin RJ-45 QuickMedia transport port outputs CAT5E/CAT6 video and
audio signals. The QM output port conforms to the 568B wiring standard.
Refer to page 2 for additional wiring information.
NOTE: To determine the location of pin 1 on a male RJ-45 plug, hold the
connector so that the cable is down and the clip is facing away from you. Pin 1
is on the far left.
NET
The two 4-pin 5 mm detachable terminal block NET connectors are used for
connection to Cresnet and expansion to other peripherals.
Pins 24 and G provide 24 VDC and ground.
Pins Y and Z provide communications (data).
Power to the unit (5 W, 0.21 A @ 24 VDC) is supplied through this connector.
SETUP LED and Pushbutton
Used for touch-settable ID (TSID) and located on the back of the unit, the
SETUP pushbutton and its associated LED are used for setting a network ID
during the initial configuration of a Cresnet system or when the device is added
or replaced.

Industry Compliance

As of the date of manufacture, the QM-TX has been tested and found to comply
with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Crestron QM-TX
Operations Guide - DOC. 6334