HoMedics UHE-CMTF91 Instruction Manual And Warranty Information page 8

PROGRAMMABLE DIGITAL HUMIDISTAT
The default humidistat setting is CO (continuous on). The programmable humidistat can be set in 5%
increments, from 35% to 55% humidity.
To program the humidity level, press the programmable humidistat button. The humidity level will
increase by 5% each time the button is pressed and will be displayed on screen. Press the humidistat
button repeatedly until the desired setting is reached. The display will show the set humidity level.
NOTE: To eliminate any programmed humidistat setting, continue to press the programmable humidistat
button until you reach CO, one level above 55%.
NOTE: When the set humidity level is reached, the humidifier will cycle off until the humidity in the room
drops 5% below the set humidity level. The unit will cycle on until the set humidity level is reached again.
TIMER
Press the timer button until the desired timer setting is displayed. The timer
through the following settings: 4 hours, 8 hours, 12 hours, and 0 hours. To cancel the timer at any time,
press the timer button until 0 hours is displayed.
NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting.
AUTO-OFF
When the water in the tank is almost gone, the humidifying function will power off and the power button
will illuminate red, indicating it is time to refill the tank.
NOTE: It is normal to have a small amount of water in the tank and water reservoir after use.
CLEAN REMINDER
The clean LED will illuminate red after 60 hours of use, indicating it is time to clean the transducer/
ultrasonic membrane. See cleaning instructions in the Cleaning and Care section. Press and hold the
clean indicator/reset
HOW TO USE
ESSENTIAL OIL
Use your favorite essential oil to deliver aroma into the air.
NOTE: For use with the included HoMedics essential oil pads only.
NOTE: Do not leave a filled essential oil pad in the oil tray of the humidifier if it will be out of use for a
long period of time.
button for 3 seconds to reset the clean indicator.
8
button will cycle