Making Utp Connections - KTI Networks KGS-1064-BP User Manual

2.8 Making UTP Connections

The 10/100/1000 RJ-45 copper ports support the following connection types and distances:
Network Cables
10BASE-T:
100BASE-TX:
1000BASE-T:
Link distance:
Auto MDI/MDI-X Function
This function allows the port to auto-detect the twisted-pair signals and adapts itself to form a valid MDI to
MDI-X connection with the remote connected device automatically. No matter a straight through cable or
crossover cable is connected, the ports can sense the receiving pair automatically and configure itself to match
the rule for MDI to MDI-X connection. It simplifies the cable installation.
Auto-negotiation Function
The ports are featured with auto-negotiation function and full capability to support connection to any Ethernet
devices. The port performs a negotiation process for the speed and duplex configuration with the connected
device automatically when each time a link is being established. If the connected device is also
auto-negotiation capable, both devices will come out the best configuration after negotiation process. If the
connected device is incapable in auto-negotiation, the switch will sense the speed and use half duplex for the
connection.
Port Configuration Management
For making proper connection to an auto-negotiation incapable device, it is suggested to use port control
function via software management to set forced mode and specify speed and duplex mode which match the
configuration used by the connected device.
2-pair UTP Cat. 3, 4, 5 , EIA/TIA-568B 100-ohm
2-pair UTP Cat. 5, EIA/TIA-568B 100-ohm
4-pair UTP Cat. 5 or higher (Cat.5e is recommended), EIA/TIA-568B 100-ohm
Up to 100 meters for all above
-19-