Working Mode; Network - TP-Link TL-WR843N User Manual


Note:
1) The WPS LED on the Router will light green for five minutes if the device has been successfully
added to the network.
2) The WPS function cannot be configured if the Wireless Function of the Router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.

Working Mode

The Router supports two working modes: Standard Wireless Router and WISP Client Router.
Please select one you want. Click Save to save your choice, which is shown as Figure 4-5.
Control the system mode by software – Tick this item, you will see the two options of working

mode. You can also select it by turn the work mode switch at the back panel of your Router.
Standard Wireless Router - In this mode, the device enables multi-users to share Internet via

ADSL/Cable Modem. The wireless port share the same IP to ISP through Ethernet WAN port.
The Wireless port acts the same as a LAN port while at Router mode.
WISP Client Router - In this mode, the device enables multi-users to share Internet from WISP.

The LAN port devices share the same IP from WISP through Wireless port. While connecting
to WISP, the Wireless port works as a WAN port at Client Router mode. The Ethernet port acts
as a LAN port.

Network

Figure 4-6 the Network menu
TL-WR843N 300Mbps Wireless AP/Client Router User Guide
Figure 4-5 Working Mode
- 28 -