Alfa Romeo Giulia Owner's Handbook Manual page 23

After selecting one heating level, you
need to wait for a few minutes until warm
air flows into the compartment.
The seat heating function can also be
activated using the Connect system:
see the description on the dedicated
supplement.
WARNING The electric heating function
cannot be activated when the engine off.
It only works with the engine running.
REAR SEATS
11)
The rear seats allow three passengers.
20
SPLIT FOLDING REAR SEAT
(where provided)
6)
The luggage compartment can be
partially (1/3 or 2/3) or totally extended
by splitting the rear seat.
Partial extension of the luggage
compartment (1/3 or 2/3)
Extending the right side of the boot
allows you to carry two passengers
on the left part of the rear seat, while
extending the left side allows you to
carry one passenger.
Proceed as follows:
completely lower the rear seat head
restraints;
place the seat belt so that it doesn't
impede the movement of the backrest
while tilting it;
operate lever (1) fig. 21 (in the boot)
to tilt the left part or lever (2) to tilt
the right part of the backrest: it will
automatically tilt forward. If necessary,
accompany the backrest during the initial
stage of tilting.
04066S0005EM
21
Repositioning the backrests
12)
Move the seatbelts to the side, making
sure that they are correctly extended
and not twisted and that they are not
trapped behind the backrests of the
seats, then lift the backrests pushing
them back until you hear the locking click
on both attachment mechanisms.
Central backrest section tilting
Before tilting the backrest, make sure
that the rear central seat belt is not
fastened and that there are no objects
in the central part of the cushion (if there
are any, remove them).
Using the device, fig. 22, release the
central part of the backrest from
its housing and tilt it using the head
restraint.
22
Central backrest section repositioning
Using the head restraint, lift the central
04066S0007EM
portion upwards, accompanying it during
its movement, lightly press to make sure
that it is properly attached.
04066S0008EM
21