Alfa Romeo Giulia Owner's Handbook Manual page 153

Assistance" menu and then selecting
"Comfort" on the Connect system.
Activating the device
After activating the camera, it will be
possible to select one of the following
options:
"Activate"
"Cam Delay"
"Camera Guidelines"
Select "Activate" to activate the camera
view on the Connect system display.
Whenever reverse gear is engaged, the
Connect system display, fig. 150, will
show the area around the car, as seen by
the Rear View Camera.
Controllare l'intera area circostante
150
SYMBOLS AND MESSAGES ON THE
DISPLAY
Activating the "Camera Guidelines"
shows the guidelines on the display.
If activated, the grid is positioned on
the image to highlight the width of the
vehicle and the expected reversing path
in accordance with the steering wheel
position.
A superimposed central broken line
indicates the centre of the vehicle to
facilitate parking manoeuvres or tow
hook alignment. The various coloured
areas indicate the distance from the rear
of the vehicle.
The table below shows the approximate
distances for each area fig. 150:
Area
Red
Yellow
Green
WARNING When parking, take the
utmost care over obstacles that may be
above or under the operating range of
the camera.
07186S0060EM
WARNING
159) Parking and other potentially
dangerous manoeuvres are, however,
always the driver's responsibility. While
carrying out these manoeuvres, always
make sure that no people (especially
children) or animals are in the area
concerned. The camera is an aid for the
driver, but the driver must never allow
his/her attention to lapse during potentially
dangerous manoeuvres, even those
executed at low speeds. Always keep a slow
speed, so as to promptly brake in the case of
obstacles.
68) It is vital, for correct operation, that
the camera is always kept clean and free
from any mud, dirt, snow or ice. Be careful
Distance from the
not to scratch or damage the camera while
rear of the
cleaning it. Avoid using dry, rough or hard
vehicle
cloths. The camera must be washed using
clean water, with the addition of vehicle
0 - 1 ft (0 – 30 cm)
shampoo if necessary. In washing stations
which use steam or high-pressure jets, clean
1 - 3.3 ft (30 cm - 1
the camera quickly, keeping the nozzle more
m)
than 10 cm away from the sensors. Also, do
not apply stickers to the camera.
3.3 ft (1 m) or more
IMPORTANT
151