Alfa Romeo Giulia Owner's Handbook Manual page 148

When the system detects that the car
has approached the lane line and is
about to overtake it, the left line on the
instrument panel display lights up yellow
and red fig. 141.
141
The system operates in the same way,
but mirrored, in the event of exiting the
right lane when only the right lane limit
has been detected.
Exiting a lane with detection of both
limits
When the system is active, the lane lines
on the display become white to indicate
the successful detection of the limits.
The system is ready to provide
indications in case of accident lane
departure (direction indicator not
activated).
In accordance with the different
conditions detected, the system can
attract the attention of the driver by
altering the lines that identify the lanes
146
on the instrument panel display. In
particular, the system can alter their
colour (from white to yellow and vice
versa).
If a lane line is crossed, this is indicated
on the display of the instrument panel by
means of a red flashing graphic symbol
and by an acoustic signal. The warning is
emitted from the loudspeakers on the
side of the lane limit being crossed (e.g. if
the vehicle is crossing the left line of the
lane, the acoustic warning will come from
the loudspeakers on the left).
Changing the system sensitivity
The system sensitivity intervention can
07226S0024EM
be adjusted using the "Driver Assistance"
menu and then selecting "Comfort" on
the Connect system.
The possible options are "High" or "Low".
System limited operation signal
60) 61)
If the dedicated message is shown on
the instrument panel display, a condition
limiting the system operation may have
occurred. The possible reasons of this
limitation are something blocking the
camera view or a fault.
If an obstruction is signalled, clean the
area of the windscreen by the interior
rear-view mirror.
Although the vehicle can still be driven
in normal conditions, the system may be
not completely available.
When the conditions limiting the system
functions end, this will go back to normal
and complete operation. Should the
fault persist, contact an Alfa Romeo
Dealership.
System failure signalling
If the system switches off and the
system appears on the instrument
panel display, it means that there is a
failure on the system.
In this case, it is still possible to drive the
vehicle, but you are advised to contact
an Alfa Romeo Dealership as soon as
possible.
IMPORTANT
56) Projecting loads on the roof of the car
may interfere with the correct operation of
the camera. Before starting make sure the
load is correctly positioned, in order not to
cover the camera operating range.
57) If the windscreen must be replaced due
to scratches, chipping or breakage, contact
exclusively an Alfa Romeo Dealership. Do
not replace the windscreen on your own, risk
of malfunction! It is advisable to replace the
windscreen if it is damaged in the area of
the camera.
58) Do not tamper with nor operate on the
camera. Do not close the openings in the