Approved Power Tool Attachments; Assembling The Unit - Stihl HL 94 Instruction Manual

English
Swing the cutter bar in an arc towards
the outside of the hedge so that the
cuttings are swept to the ground.
Recommendation: Only cut hedges that
are no more than chest high.
10
Approved Power Tool
Attachments
The following STIHL attachments may
be used with the basic power tool:
Attachment Application
1)
HL 0°, 500 mm Long reach hedge
trimmer
1)
HL 0°, 600 mm Long reach hedge
trimmer
HL 145°, Long reach hedge
1)
500 mm trimmer
HL 145°, Long reach hedge
1)
600 mm trimmer
2)
HT Pole pruner
2) 3)
BF Cultivator with pick
tines
SP 10 Special harvester
1)
Loop handle required on versions
with long drive tube (HL 92, HL 94)
2)
Must not be mounted to versions
with short drive tube (HL 92 K, HL
94 K)
3)
Loop handle required

Assembling the Unit

Mounting the Loop Handle (HL 92,
HL 94)
Loop handle is required on versions with
long drive tube (HL 92, HL 94).
7
8
2
3
5
6
9
Place the clamp (1) in the loop
N
handle (2) and position them both
against the drive tube (5) between
the carrying ring (3) and handle
hose (4).
Position the clamp (6) against the
N
shaft.
Line up the holes.
N
Insert the screws (7) with
N
washers (8).
Fit the square nuts (9) and screws.
N
HL 94, HL 94 K
7
8
1
4
9