Table of Contents
Advertisement
10. Firmly slide the assemblies together until the tray-release button securely
11. Connect the auxiliary power cable (A), as shown in the following illustration.
12. Connect the cable to the expansion-unit system board. Replace the retention
13. If you have other devices to install or remove, do so now; otherwise, go to
Completing the installation
To complete the installation, complete the following steps:
1. Install any expansion blades that were removed and the expansion blade cover
2. Insert the combined blade server and expansion blades into the BladeCenter
9. Carefully reposition the expansion-unit riser assembly, aligning it with the
expansion-unit system-board-assembly rails.
locks the panels.
A
bracket and tighten the screws (B), as shown in the illustration above.
"Completing the installation."
(see "Installing a GPU Expansion Blade" on page 8 and "Installing the
expansion blade cover" on page 15).
unit (see the documentation for your blade server and BladeCenter unit for
additional installation information).
B
Chapter 3. Installing options
21
Advertisement
Table of Contents
