Table of Contents
Advertisement
Available languages
Available languages
Maintenance
To ensure best performance, the discharge tunnel plug
must be cleaned after each use. When grass is thick
and lush, clippings may collect on and around the
plug; this may make plug removal difficult. After
each use, remove plug from discharge tunnel and
clean off all debris.
Always be sure that discharge tunnel door locks
closed when handle is released. If debris prevents
discharge door from locking closed, clean inside of
discharge tunnel and door thoroughly.
1.
Stop engine and pull wire off spark plug.
Remove key from switch (key start models).
2.
Remove fuel tank cap. Use a pump-type syphon
to drain fuel into a clean gas can.
Note:
This is the only procedure
recommended for draining fuel.
3.
Tip mower on side; refer to mower's Operator's
Manual for proper side to use. Avoid rotating
blade because starting problems may result.
4.
Remove dirt and grass clippings that stick to
housing with a hardwood scraper. Avoid burrs
and sharp edges.
5.
Turn mower upright.
6.
Remove debris from inside of discharge tunnel.
7.
Clean discharge tunnel plug and reinstall it.
8.
Refill fuel tank.
EN–5
Advertisement
Table of Contents
