Adjusting The Horizontal Direction Of The Sonar Beam - Simrad SX90 Quick Start Manual

Fish finding sonar

Hide thumbs Also See for SX90:

Table of Contents

or:

Place the cursor on the button. Press and hold the left mouse button. Move the cursor

horizontally over the button. Release the mouse button when requested value is shown.

or:

Select the middle of the button to open it. If you have a keyboard connected to the

SX90, you can type the requested value.

Open the button and select

views in the current presentation mode.

Adjusting the horizontal direction of the sonar beam

The Horizontal view in the SX90 presentation covers the entire 360° omnidirectional sector

For the other views you must define the horizontal direction of the beam.

Context

In the Horizontal view the current bearing is shown with a continuous line pointing out

from the vessel position. The area covered by the vertical beam is shown as a triangle in

the Horizontal view.

Note

The choice you make is by default only applied to the currently selected (active) view. The

active view is identified with a thicker border.

A new tracked object is automatically given priority status. The priority is identified with a

"P". The bearing and tilt settings are automatically adjusted to follow the movements of the

tracked target. The bearing line is automatically locked on the object to reflects its bearing.

Procedure

Click in the view you want to activate.

The active view is identified with a thicker border. Unless you use the

function, all changes you make will only be applied to this view.

386619/C

if you wish to use the chosen setting in all the

Apply to all

Getting started

Apply to all

Table of Contents