Starting Normal Operation; Turning On The Sx90 For Normal Use - Simrad SX90 Quick Start Manual

Simrad SX90 Quick Start Guide

Starting normal operation

Topics
Turning on the SX90 for normal use, page 18
Getting to know the user interface, page 20
Getting to know presentation modes and views, page 22
Selecting Normal mode to start "pinging", page 26
Adjusting the radius of the search area, page 28
Adjusting the echo sensitivity, page 29
Changing the vertical angle of the sonar beams, page 31
Adjusting the horizontal direction of the sonar beam, page 33
Turning off the SX90, page 35

Turning on the SX90 for normal use

In order to use the SX90, you must first turn it on. To turn on the SX90 use the
button on the Operating Panel. The SX90 program starts automatically when the Processor
Unit is turned on.
Caution
You must never start SX90 transmissions (pinging) when the ship is in dry dock. The
transducer may be damaged if it transmits in open air.
Procedure
1 Make sure that you have sufficient water depth below the keel before you lower the
transducer.
2 Turn on the display(s).
If required, refer to the instructions provided by the display manufacturer.
3 On the Operating Panel, press
18
, and keep it depressed for a few seconds.
Power
Power
386619/C