Reinstalling The Lower Hinge Pin; Removing The Handles - Dometic DMC4101 Installation And Operation Manual

Door Swing Reversal

6 .4 Reinstalling the Lower Hinge Pin

This section describes reinstalling the lower hinge
bracket.
w
e
q
r
w
11 Reinstalling the Lower Hinge Bracket and Hinge Pin
Hinge-Side Leveling Foot
q
Lower Hinge Bracket
w
I Keep all the hardware and screws for reinstallation.
1. On the lower hinge bracket, use a flathead
screwdriver to remove the hinge pin. Place the hinge
pin into its new bracket slot, immediately next to its
original position.
I The hinge pin must change slots to remain in an
outer edge position after swapping swing sides.
2. Holding the lower hinge bracket in its new location,
use the hinge-side leveling foot to hold the hinge
bracket loosely to the bottom of the refrigerator. Turn
the foot clockwise until secure.
3. Install the mounting screws, using the outer edge top
and lower slots, and the inner middle slot. Tighten
securely.
4. Install the remaining leveling foot on the opposite
side of the refrigerator.
10
Mounting Screws
e
Hinge Pin
r

6 .5 Removing the Handles

This section describes removing the handles and decor
well covers.
q
12 Removing the Handles and Decor Well Covers
Door Handle
q
I Keep all the hardware and screws for reinstallation.
1. Depress the freezer door handle latch to remove the
two Phillips head screws that secure the handle.
2. While using a screwdriver to push in the handle's
plunger pin completely and depressing the handle
latch, lift the handle out of the handle well.
3. On the opposite edge of the door, pop off the freezer
decor well cover.
4. Snap the decor well cover onto the original handle
well location. Align the cover under the edge of the
door cap.
5. Repeat steps 1 through 4 for the fresh food door.
I At reinstallation, the freezer handle will rotate 180°
to become the fresh food handle. The fresh food
handle will rotate 180° to become the freezer door
handle.
DMC Refrigeratorss
w
Decor Well Cover
w
EN