Reversing The Door Hinge - Dometic RM 123 Installation And Operating Manual

Installing the refrigerator
7.4 Fixing the refrigerator
➤ Secure the refrigerator in the recess to prevent movement.
Screw metal brackets about 20 mm (3/4") wide (which should be made to suit
the particular installation) to the rear of the refrigerator by means of the two exist-
ing cooling unit fixing screws and to the rear wall of the caravan.
7.5 Installing exhaust duct system
The flue gas is vented directly through the upper grille. Do not use any kind of alu-
minium flue pipe to lead the flue gas out.
➤ Align the T-piece (fig. g, page 8) at 45° with the exterior wall and fix it with
screws to the chimney tube.
7.6 Installing the cover plate above the refrigerator door
➤ Screw a block of wood on each side with the dimensions 25 x 66 mm to both
sides of the recess.
➤ Mount the blocks 16 mm offset inwards, so that the cover plate is flush to the front
of the kitchen cabinet (fig. 8 2, page 5).
➤ Screw the cover plate on the blocks.
7.7

Reversing the door hinge

A
NOTICE! Risk of damage
Lay the refrigerator on the side only, never on the back. Otherwise the
cooling pipes may be damaged.
The refrigerator is delivered with the door hinge on the right. To reverse the door
hinge, follow the steps below:
➤ Turn the refrigerator on the side.
➤ Pull the knob of the temperature switch.
➤ Loosen the two screws and remove the lower cover plate.
➤ Remove the top hinge leaf and the closure plate.
➤ Hold the upper hinge leaf and the closure plate to the desired side and attach it
to the lower hinge leaf from the opposite side.
➤ Install the vent grille with the two screws.
16
RM122, RM123
EN