Setting Up The Remote Control; Changing The Battery; Using The Heater - Westinghouse WSHPTCBN1901 Instruction Manual

SETTING UP THE REMOTE
CONTROL
Pull the plastic film from the battery compartment. The battery is
now active, and you can use the remote control.
Operating range of the remote control: Point the remote control
at the heater making sure there are no obstacles between the
remote control and the heater's infrared sensor. The remote control
can connect to the heater within 16 feet. The range may vary
depending on the brightness of the room.

CHANGING THE BATTERY

1. Push the release button inwards and pull the battery casing
out. Remove the old battery.
2. Insert 1 x CR2025 3V battery into the battery casing ensuring
you follow the polarity (+ and -) marked on the casing.
3. Slide the battery casing back into the remote control until you
hear it click firmly into place.
WARNING: Do not expose the infrared remote sensor to direct
sunlight or other strong light, such as a florescent light.
NOTE: Make sure there are no obstacles between the remote
control and heater's infrared sensor on the control panel.

USING THE HEATER

NOTE: The buttons for operating the heater on the heater control
panel and the remote control are the same except for the +/-
button (15). When you press the +/- button (15) on the heater
control panel, it will scroll upwards through the numbers, but
you cannot scroll through the numbers in reverse order. To scroll
through the numbers in reverse, press the DOWN button (15) on
the remote control.
1. Press the POWER switch (2) to the on position I. The switch's
red indicator light will illuminate.
2. Press the ON/OFF button (10) on. The fan mode will start, and
the LED screen will display the fan icon
room temperature i.e. 23°C.
EN
10
HOW TO USE
and the current