Setting Up The Remote Control; Changing The Battery - Westinghouse WSHPTCNSK52 Instruction Manual

SETTING UP THE REMOTE
CONTROL
• Pull the plastic film from the battery compartment. The battery
is now active, and you can use the remote control.
• Operating range of the remote control: Point the remote
control at the heater making sure there are no obstacles
between the remote control and the heater's infrared sensor.
The remote control can connect to the heater within 10 to 16.5
feet / 3 to 5 meters. The range may vary depending on the
brightness of the room.

CHANGING THE BATTERY

1. Push the release button inwards and pull the battery casing
out. Remove the old battery.
Remote control
2. Insert 1 x CR2025 3V battery into the battery casing ensuring
you follow the polarity (+ and -) marked on the casing.
3. Slide the battery casing back into the remote control until you
hear it click firmly into place.
WARNING: Do not expose the infrared remote sensor to direct
sunlight or other strong light, such as a florescent light.
NOTE: Make sure there are no obstacles between the remote
control and heater's infrared sensor on the control panel.
EN
12
HOW TO USE
Battery cover
PULL
PUSH
Battery