Disassembly And Replacement - Bosch Rexroth ErgoSpin Series Installation Instructions Manual

86/104 Bosch Rexroth AG

Disassembly and replacement

11 Disassembly and re-
placement
CAUTION
The product is not protected against
incorrect assembly/disassembly!
Risk of injury and damage to the device during
subsequent operation.
Assemble/disassemble the product

according to the following information and
in the correct order.
Only qualified personnel are authorized to

assemble/disassemble the product.
Do not clamp the hand-held nutrunner into

a vise or the like.
Pull the plug out of the socket before

assembling/disassembling accessory
parts.
ErgoSpin/CC-ErgoSpin | 3608870H86/2020-01
CAUTION
Improper handling!
Under unfavorable conditions, handling or
assembling/disassembling specific parts and
components in an unsuitable manner could
cause injuries. Injury due to crushing,
shearing, cutting, impact!
Observe the general construction and

safety regulations for handling and
assembly/disassembly.
Use suitable assembly/disassembly and

transport equipment.
Prevent trapping and crushing injuries by

using suitable precautions.
Only use suitable tools.

Use special tools if stipulated.

Use tools appropriately.

If necessary, use suitable protective

equipment (e. g. protective goggles,
safety shoes, protective gloves).
Do not stand under suspended loads.

Lay cables and lines in accordance with

the permissible bending radiuses so that
they cannot be damaged and no one can
trip over them.
To disassemble the hand-held nutrunner,
take the following individual steps:
Loosening the ErgoSpin connecting cable

Disassembling the output drive
