Table of Contents
Advertisement
7.
Maintenance
Do not carry out any maintenance work that is not spe-
cifically recommended in this chapter. Non-compliance
invalidates warranty.
7.�
Spare and wearing parts
Description
Filling nozzle
Braided hose for outlet
Vacuum pump oil
>)
>) Offered only for vacuum pump
7.2
Replacement of spare parts
7.2.�
Replacing the air filling connector
1. Switch off the master switch of the NTI 1000.
2. Open the front door.
Risk of injury due to pressure in the hoses
High pressure in the hoses might cause the
hoses to fly apart and cause injury.
¶
Ensure that the pressure of the nitrogen
tank is less than 2 bar before replace-
ment.
i
To reduce the pressure, open the safety valve of the
nitrogen tank till the pressure drops to 2 bar.
i
To open the safety valve (Fig. 8, Pos. 1), rotate the
valve in the anticlockwise direction.
Bosch Limited
Order number
F 002 DG1 A23
F 002 DG1 A24
F 002 DG6 401
Maintenance | N�� ���� | �5
Fig. 8:
Opening the safety valve on the nitrogen tank
1 Safety valve
!
Ensure that you tighten the safety valve of the tank
after releasing the pressure. If the safety valve is
not tightened, the nitrogen filled into the tank will
escape and the operating pressure of 10 bar will not
be achieved.
3. Loosen the hose clip that fastens the filling nozzle to
the braided hose.
4. Disconnect the filling nozzle from the braided hose.
5. Connect the new filling nozzle connector.
6. Place the hose clip and tighten the screws.
i
Ensure that the orientation of the air filling connec-
tor is in the correct position. To check, connect the
filling nozzle to a tire. If the braided twists, repeat
the above procedure and adjust the position of the
air filling connector.
N�� ���� | �5
| �5
en
|
F 002 DG9 A00
2013-04-16
Advertisement
Table of Contents
