Telnet Session; Logging In To The Mx410/Mx412 - ADTRAN MX410 System Manual

Logging in to the MX410/MX412

– no parity (none)
– one stop bit
– no flow control
2. Set the PC for direct connect on the appropriate communications port (as opposed to dial
up connection).
3. Plug the male end of the data cable into the MX410/MX412. Make connection to the PC or
laptop as appropriate for the equipment.

Telnet Session

To access the MX410/MX412, use an appropriate Telnet client to access the management
interface of the MX410/MX412 at the configured IP address.
LOGGING IN TO THE MX410/MX412
To logon to the MX410/MX412, perform the following steps:
1. Establish the physical connection to the MX410/MX412 using a craft port session or
enter the default IP address "192.168.100.1" with a subnet mask of "255.255.0.0." to
establish a Telnet session.
2. Enter the default username "ADMIN" in all capital letters, and press
3. Enter the default password "PASSWORD" in all capital letters, and press
Login username and password fields are case sensitive. The default
values are all uppercase.
5-2 PRELIMINARY
NOTE
MX410/MX412 System Manual
.
E
NTER
.
E
NTER
61189500L1-1B