Difficulty Storing Numbers In Memory - ClearSounds CSC 600 Installation Manual & User Manual

Audible/Visual indicator, the light will contine to flash after reviewing
your voice mail messages.

Difficulty storing numbers in memory

1 Make sure you are pressing the correct sequence of buttons for storing
numbers.
2 If you are interrupted by the telephone company's recorded announcement
telling you to hang up or by a loud buzzing noise, ignore and continue
to store the numbers. or hang up and store the number without lifting
the handset or temporarily disconnect the telephone line until you have
programmed in all the numbers.
no numbers dialed when memory button is pressed
1 No number stored in that memory button.
2 Make sure phone number was programmed and saved in the memory
3 Make sure programming is done in the correct dial mode (touch-tone or
pulse dialing).
4 If your phone has been disconnected for a few hours the numbers stored
will be lost.
Caller ID information does not show
1 Make sure you are subscribed to Caller ID through your local phone
company.
2 Check batteries. (If you have experienced a power failure, the batteries
for memory back-up could become weak.)
no Caller ID information while on a call
1 Make sure your service provides Caller ID Information while you are on
a call. This is sometimes known as "Caller ID on Call Waiting" or "Type II
Caller ID".
2 Make sure you have the Caller ID – Caller Waiting feature on this phone
set to oN
3 The phone cannot display the information if another phone on the same
line is in use. Make sure all extensions are on hook.
Cannot dial out of Caller ID
1 Make sure you are subscribed to Caller ID through your local phone
company.
2 Make sure your area code is set up properly.
18 – ENGLISH
.