MULTIQUIP Whiteman J36 Series Operation Manual page 22

Figure 7. Throttle Cable Receiver Adjustment
NOTICE
If the throttle lever does not return to the "neutral"
position with throttle backed off, loosen adjuster nut 1/2
turn at a time, tighten and recheck. Readjust throttle
tension as necessary.
Safety Stop Switch Connection
1. Connect the black tail wire from the engine to the black
safety stop wire from the centrifugal stop switch as
shown in Figure 8.
Figure 8. Safety Stop Switch Connection
PAGE 22 — J36/B46-M30 SERIES WALK-BEHIND TROWELS • OPERATION MANUAL — REV. #0 (10/27/16)
*Always follow manufacturer instructions*
ASSEMBLY AND INSTALLATION
Pitch Cable Installation
1. For Standard Handle models extend the pitch cable
2. For Quick Pitch™ Handle models extend the pitch cable
SAFETY STOP WIRE
CONNECTION POINT
3. Remove brass set nut #1 from the blade pitch cable
*AAA Rent-All 225-291-1356*
to maximum length by turning the blade pitch star
wheel (Figure 9) fully counterclockwise for no pitch
(blades flat).
INCREASE
BLADE PITCH
(CW)
Figure 9. Blade Pitch Star Wheel
(Standard Handle)
to maximum length by grasping the T-handle (Figure 10),
then squeezing the trigger lock and pushing the
T-handle forward for no pitch (blades flat).
T-HANDLE
TRIGGER
(SQUEEZE)
NO PITCH
FORWARD
Figure 10. Blade Pitch T-Handle
(Quick Pitch™ Handle)
end as shown in (Figure 11).
BRASS SET
NUT #1
BRASS SET
NUT #2
Figure 11. Blade Pitch Cable
DECREASE
BLADE PITCH
(CCW)
BLADE
PITCH
CABLE