Using Nord Stage With A Sequencer; Midi Channel - Clavia Nord Stage User Manual

Revision c, os version 3.1x
Hide thumbs Also See for Nord Stage:
Table of Contents

Advertisement

Nord Stage v3.1x
P
C
ROGRAM
On the MIDI Menu (see
gram Change messages.
When you select a Program, a Program Change message is transmitted via MIDI on the active Panel
MIDI Channel. If a Program Change message is received on any of the Panel A/B MIDI Channels,
Nord Stage will change Program accordingly.
Note! A program change on either of the two Panel MIDI Channels will affect both Panels.
The 126 Program locations send and respond to MIDI Program Change values 0-125. Live buffers 1-
2 correspond to MIDI Program Change 126-127.
MIDI S
E
YS
X
Single Programs/Synth sounds or all Programs/all sounds can be transmitted and received as a Sys-
tem Exclusive dump (see
U
N
SING
ORD
C
ONNECTIONS
1. Connect the MIDI Out on the Nord Stage to the MIDI In on your sequencer.
2. Connect the MIDI Out from your sequencer to the MIDI In on the Nord Stage.
Make sure that the Nord Stage is configured to respond to Program Change and Control Change
MIDI messages (see the
L
O
/O
OCAL
N
Local Off should be used when you use a sequencer to record and play back from Nord Stage. Since
the sequencer echoes back incoming MIDI data, Nord Stage will respond normally to your playing
and knob tweaking via the MIDI "loop". If you use Local On with a sequencer setup as described
above, this would cause "double-triggered" notes when you play; both from the keyboard internally
and via the MIDI "loop". Therefore, always use Local Off when used in this way together with a se-
quencer.
Local On/Off is set on the
MIDI
CHANNEL
Each Panel can respond its own MIDI channel. This is convenient when you want to play split and
layered sounds. If you want to control each instrument separately, you can assign an individual MIDI
channel to each of the six instruments of the Nord Stage. The MIDI channels are set up on the MIDI
menu - see
"MIDI menu" on page
P
C
ROGRAM
Usually you select a Program Change value for a track in the sequencer track settings. The 126 Pro-
gram locations send and respond to Program Change values 0-125., while Live buffers 1-2 corre-
spond to Program Change 126-127. Make sure the Program Change is sent on either of the Panel A/
B MIDI channels.
HANGE
page
68), you can select if the Nord Stage should send and/or receive Pro-
(S
E
YSTEM
XCLUSIVE
"Sending Program dumps" on page
S
TAGE WITH A SEQUENCER
"MIDI menu" on page
FF
"MIDI menu" on page
68.
HANGE
14. MIDI functions: Using Nord Stage with a sequencer
)
88).
68).
68.
Page 87

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents