Tunturi E60-R Assembly Manual page 19

‼ NOTE
• Part numbers shown in the assembly steps
are commencing with the spare part drawing
that can be found in the online full version
user manual.
⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least
two persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around
the equipment.
• Refer to the illustrations for the correct
assembly of the equipment.
Additional assembly information�
D3 How to fit the pedals correctly�
‼
NOTE
• Right and left side are determined from an
exercising positions perspective.
Right hand pedal
Find the "R" or "L" mark on the pedal axle
- Fit the right hand pedal "R" into the right hand
crank.
- Firstly turn the pedal axle in clockwise direction
by hand.
- Use the wrench to fully tighten the pedal.
Left hand pedal
- Fit the left hand pedal "L" into the left hand
crank.
- Firstly turn the pedal axle in counter-clockwise
direction by hand.
- Use the wrench to fully tighten the pedal.
Additional information to Assembly step
D5
- Establish the wire connection between the
cable coming from the main frame, and the
lower part of the cable pre fitted in the upright
tube.
- Place the upright tube over the main frame
fixing bracket, in where the fixing bolts are pre-
assembled and stay pre-assembled.
( While lowering the upright tube, gently pull
the upper part of the cable up, to avoid the
cable get caught by the connection. )
- The upright tube should automatically find the
centre position, but it is advisable to make the
slightest correction needed to make sure the
position is good.
- The perfect position is when the fixing bolts are
perfectly centred in line with the upright tube
holes.
‼ NOTE
• Avoid the cable connection between these
two parts get pinched.
• By fastening the two bolts (turning in
clockwise direction) on the front side you will
widen the fixing bracket so the upright gets
fixed firmly.
- To fix the upright tube firmly it is needed to
tighten the bolt on the upper side first firmly.
- After fixing the upper bold, you need to fix the
lower bold firmly.
- By fixing the lower bold, the upright tube will
be repositioned slightly resulting that the upper
bold can be fixed a little more, therefore it is
needed to fix the upper bolt again.
- Repeat these steps until both bolts are firmly
fixed to ensure the upright tube fixation well.
‼ NOTE
• Save the tools provided with this product,
after you completed the product assembly,
for future service purposes.
Use
Adjusting the support feet
The equipment is equipped with 5 support feet. If
the equipment is not stable, the support feet can
be adjusted.
- Turn the support feet as required to put the
equipment in a stable position.
- Tighten the locknuts to lock the support feet.
‼ NOTE
• The machine is the most stable when all
support feet are turned fully in. Therefore
start to level the machine by turning all
support feet fully in, before turning out the
required support feet to stable the machine.
English
19