Table of Contents
Advertisement
The following required information for connection is specified in the technical data:
● Direction of rotation
● Number and arrangement of the connections
● Circuit / connection of the machine winding.
4.7.2
Terminal box
NOTICE
Please observe the tightening torques for cable glands and other nuts and bolts
When performing a test run, secure the feather keys without output elements.
NOTICE
Do not damage the terminal box or other functional parts inside the terminal box
NOTICE
It must be ensured that there are no foreign bodies, dirt or moisture in the terminal box
The terminal box must be sealed so that dust and water cannot enter.
Seal the terminal box with the original seal. Seal cable entries to the terminal box and other
open cable entries with an O-ring or suitable flat gasket.
Note
For a standard terminal board with 6 terminal studs, the terminal box can be turned 4 x 90
degrees on the terminal base of the machine housing.
The temperature sensor and anti-condensation heating are connected in the terminal box.
BA 2320
Operating Instructions, 02/2015, 70000004023775
Mounting
4.7 Connecting the motor
31
Advertisement
Table of Contents
