Setup > Time; Set Time; Local Time; Daylight Saving - Cisco SRW2016 User Manual

Chapter 5
Click Save Settings to save your changes. Click Cancel
Changes to cancel your changes.
Setup > Time
The Time screen allows you to configure the time settings
for the Switch.
Setup > Time

Set Time

Use System Time Select this option to use the local
hardware clock.
Use SNTP Time
Select this option to synchronize the
time to an SNTP (Simple Network Time Protocol) server.

Local Time

Hours Enter the two-digit hour here.
Minutes Enter the two-digit minutes here.
Seconds Enter the two-digit seconds here.
Month Enter the two-digit month here.
Day Enter the two-digit day here.
Year Enter the last two digits of the year here (for example,
08 instead of 2008).
Time Zone Select your time zone from the drop-down
menu. Time zones are identified by the difference between
Greenwich Mean Time (GMT) and local time.

Daylight Saving

Daylight Saving Select Daylight Saving to enable it on
the Switch. If the Switch should use US daylight savings,
then select USA. If the Switch should use EU daylight
savings, then select European. If it should use another
kind of daylight savings, then select Custom and complete
the From and To fields.
WebView Switches
Advanced Configuration
Time Set Offset For non-US and European countries,
specify the amount of time for daylight savings. The
default is 60 minutes. The range is (1–1440).
From If you selected Other for the Daylight Saving setting,
enter the date and time when daylight savings begins.
To If you selected Other for the Daylight Saving setting,
enter the date and time when daylight savings ends.
Recurring If you selected Other for the Daylight Saving
setting and daylight savings has the same start and end
dates and times every year, select Recurring.
From If you selected Recurring, enter the date and time
when daylight savings begins.
To If you selected Recurring, enter the date and time
when daylight savings ends.

SNTP Servers

Server1 Enter the primary SNTP server here.
Server2 Enter a secondary SNTP server here.
SNTP Polling Interval (60–86400 sec)
amount of time (in seconds) before the Switch polls the
SNTP server. The default value is every 1024 seconds
(approx. 17 minutes).
Click the Save Settings button to save your changes or
click Cancel Changes to discard the information.
Specify the
22