Table of Contents
Advertisement
1.
Ensure that the hair clipper is empty of power, is switched off and
disconnected from the mains household power outlet.
2.
Remove the comb attachment.
3.
Hold the hair clipper in one hand so that the blades are at the top, and the
front of the hair clipper is facing you.
4.
Place your thumb of the opposite hand underneath the blades at the front of
the unit, hold the back of the blade set with your fore finger and middle finger
and firmly press upwards with your thumb. The blade set will detach from the
hair clipper.
5.
Brush the accumulated hair from the hair pocket and blades.
6.
Replace the blade set by inserting the notch (on the inside at the bottom of
the blade set) into the groove of the hair pocket and firmly push down with the
palm of your hand until you hear an audible 'click' and the blade set is locked
into place.
Storage
When not in use, unplug the hair clipper and store it out of reach of children in a
safe dry place. Never wrap the cord around the hair clipper as this will cause the
cord to wear prematurely and break. Handle the cord carefully for long life and
avoid jerking, twisting or straining especially at the plug connections.
TROUBLESHOOTING
The hair clipper does not work when turned on:
Hair clipper must be charged for a full 16 hours, or use hair clipper while plugged
into wall.
Hair clipper cutters do not move:
The cutting unit may be dirty and clogged. Clean the unit as directed in Cleaning &
Maintenance section on page 7.
Hair clipper does not hold charge:
Fully discharge the battery by running hair clipper until it stops; then follow
recharging instructions in Charging Your Hair Clipper section on page 5.
THIS PRODUCT IS NOT SUITABLE TO USE IN THE BATH OR SHOWER.
This product conforms to radio frequency interference requirements
Any product purchased and used commercially carries a limited 90 Day Warranty.
8
Advertisement
Table of Contents
