Vertex Standard VX-230 Service Manual page 13

5. M S
IC ENSE
This parameter is to align the Microphone Sense (Gain) and it needs the appropriate JIG (Tuning Interface BOX). Connect the JIG
and Test Equipment to the radio before the alignment is going to start. It must be done alignment of the "Max Deviation" before this
alignment is going to start.
1. Click the "PTT" button, then the radio starts to transmit on
selected channel.
2. Set the value to get desired Microphone Sense on the devia-
tion meter by drag the slide bar, click the up-down button,
press the left or right key, or enter the value on the entry
box.
3. After getting the desired deviation then click "PTT" button
to stop the transmit.
4. Click "OK" button to finish the Mic Sense alignment and
save the data.
6. M D
AXIMUM EVIATION
This parameter is to align the Maximum Deviation (Wide/Narrow) and it needs the appropriate JIG (Tuning Interface BOX). Connect
the JIG and Test Equipment to the radio before the alignment is going to start.
1. Click the "PTT" button, then the radio starts to transmit on
selected channel.
2. Set the value to get desired deviation (Wide: 4.2kHz, Nar-
row: 2.1kHz) on the deviation meter by drag the slide bar,
click the up-down button, press the left or right key, or enter
the value on the entry box.
3. After getting the desired deviation then click "PTT" button
to stop the transmit.
4. Click "OK" button to finish the Max Deviation alignment
and save the data.
ADJ Type
Single : Alignment value change only to selected channel.
All Freq : Alignment value change for connecting with other
channels.
<W > / <N >
IDE ARROW
Alignment
13