Crestron 4 Series Quick Start Manual

DIN-AP4
4-Series™ DIN Rail Control System
The Crestron® DIN-AP4 is a control system designed specifically for
DIN rail mounting applications. The DIN-AP4 features a powerful
4-Series™ control engine and provides numerous integrated control ports.
The DIN-AP4 serves as the core processor for controlling a complete
DIN rail automation system.
In the Box
1 DIN-AP4, 4-Series™ DIN Rail Control System
Additional Items
1 Connector, 2-Pin (2020549)
2 Connector, 4-Pin (2020555)
2 Connector, 5-Pin (2020548)
2 Connector, 8-Pin (2020551)
1 Connector, 9-Pin (2020552)
Mount the DIN-AP4
The DIN-AP4 can be mounted onto a standard DIN rail (not included).
Observe the following prior to mounting the DIN-AP4:
Use in an electrical panel with DIN rail mounting provisions.
l
Mount in a well-ventilated area.
l
Do not block the venting holes.
l
CAUTION: To prevent overheating, do not operate the DIN-AP4 in an
area that exceeds the environmental temperature range (41 to 113 °F or
5 to 45 °C) for this device.
To mount the DIN-AP4:
1. Hang the DIN-AP4 on the top of the DIN rail.
2. Align the bottom of the DIN-AP4 with the DIN rail, then snap the
DIN-AP4 into place.
To remove the DIN-AP4 from the DIN rail:
1. Turn off the power to the DIN-AP4.
2. Remove all connections from the DIN-AP4.
3. Use a small, flat-head screwdriver to pull the DIN rail release tab down.
4. Tilt the bottom of the DIN-AP4 away from the bottom of the DIN rail,
then remove the DIN-AP4.
Quick Start
1