Verifying Your Installation - Cisco 815 Hardware Installation Manual

Verifying Your Installation

1
Power supply
Step 2
Step 3
Step 4
Step 5
Verifying Your Installation
Cisco 815 Integrated Services Router Hardware Installation Guide
2-6
Connect one end of the separate power cord to the socket on the power supply.
Connect the other end of the separate power cord to a power outlet.
Press the router power switch to ON ( | ).
Confirm that the router has power by checking that the PWR LED on the front
panel is on.
You can verify that you have correctly installed the router by checking the
following LEDs:
PWR (front panel)—On when power is being supplied to the router.
•
OK (front panel)—On when the router software is loaded and functional.
•
Blinking indicates that the router is performing a power-on self-test (POST).
WIC0/WIC1 OK (back panel)—On when the WIC is correctly installed in the
•
corresponding WIC slot.
ETH ACT (front panel)—Blinking when there is network traffic on the local
•
10/100 Ethernet LAN.
WIC0 ACT or WIC1 ACT (front panel)—Varies, depending on the WIC
•
installed. See Table 1-4
LINK (back panel)—On when the router is correctly connected to the local
•
Ethernet LAN through the 10/100 ETHERNET port.
MOD OK (back panel)—On when the VPN hardware encryption module is
•
installed and recognized by the Cisco IOS software.
2
Power socket
in Chapter 1, "Overview."
Chapter 2 Installation
OL-9558-01