Table of Contents
Advertisement
Checking the Installation
Checking the Installation
This section describes the procedures you can use to verify the SIP and SPA installation, and includes
information on the following topics:
Verifying the Installation
This section describes how to verify the SIP and SPA installation by observing the SIP LED states, the SPA
LED states, and the information displayed on the console terminal.
When the system has reinitialized all interfaces, the SIP STATUS LED should be green (on) and the SPA
STATUS LEDs should be green (on). The port LEDs (C/A and A/L) may be green (on), depending on your
connections and configuration. The console screen also displays a message as the system discovers each
interface during its reinitialization.
The following sample display shows the events logged by the system as a SIP with a POS SPA was removed
from module slot 4 in the router. In this example, interface 0 (interface 4/0/0) on the POS SPA was up and
active when the SIP was removed from the router. Note that the system logs that the SIP card was removed
from slot 4 and that interface 4/0/0 is changed to down .
Router#
00:06:17:%WS_ALARM-6-INFO:ASSERT CRITICAL slot 4 Active Card Removed OIR Alarm
00:06:17:%OIR-6-REMCARD:Card removed from slot 4, interfaces disabled
00:06:18:%LINEPROTO-5-UPDOWN:Line protocol on Interface pos4/0/0, changed state to down
When you reinsert the SIP with the installed POS SPA, the system automatically brings up the interface that
was changed to down when the SIP was removed.
Router#
00:07:29:%OIR-6-INSCARD:Card inserted in slot 4, interfaces administratively shut down
00:07:32:%WS_ALARM-6-INFO:CLEAR CRITICAL slot 4 Active Card Removed OIR Alarm
00:07:35:%LINK-3-UPDOWN:Interface pos4/0/0, changed state to up
00:07:36:%LINEPROTO-5-UPDOWN:Line protocol on Interface pos4/0/0, changed state to up
Use the following procedure to verify that a SIP and SPA are installed correctly:
Step 1
Observe the console display messages and verify that the system discovers the SIP, while the system reinitializes each
interface, as follows:
• As a SIP is initialized, the STATUS LED will first be amber, indicating that power is on, but the SIP is being
configured. When the SIP is active, the STATUS LED will illuminate green.
• SPAs will follow the same sequence after the SIP has completed its initialization. The SPA STATUS LEDs will
illuminate amber, turning to green when the SPAs become active.
Step 2
When the SIP and SPA STATUS LEDs are green, all associated interfaces are configurable.
Refer to Cisco ASR 9000 Series Router Getting Started Guide and Cisco ASR 9000 Series Router Interface and Hardware
Component Configuration Guide for configuration instructions.
• If a SIP or SPA is replaced with a module of the same type (as in an OIR or hardware swap), the previous configuration
is reinstated when the SIP or SPA becomes active.
• If a SIP or SPA has not been previously installed in the same slot or subslot, then the configuration for all associated
interfaces is empty.
Cisco ASR 9000 Series Aggregation Services Router SIP and SPA Hardware Installation Guide
96
Installing and Removing a Shared Port Adapter
Advertisement
Table of Contents
