Required Equipment - Cisco 805 Install Manual

Required Equipment

Caution
should be between 1 and 10 megohms (Mohms).
Required Equipment
You need to provide the following equipment:
•
The hub, server, workstation, or PC that you plan to connect to the Ethernet port. The
server, workstation, or PC must have a 10- or 10/100-Mbps network interface card
(NIC).
•
The asynchronous modem or channel service unit/data service unit (CSU/DSU) that you
plan to connect to the serial port.
•
The serial cable that connects the router to the serial device. For information on
selecting and ordering the serial cable, refer to Appendix A, "Selecting a Serial Cable."
•
The terminal or PC with which you plan to configure the software or troubleshoot the
router.
Caution
anchors to secure the three 1/8-in. (M3) screws. If the screws are not properly
anchored, the strain of the network cable connections could pull the router from
the wall. Use the drill bit size that is specified by the hollow-wall anchor
manufacturer.
2-4
Cisco 805 Router Hardware Installation Guide
Periodically check the resistance value of the antistatic strap, which
If you are mounting the router on drywall, use three hollow-wall