Cisco 805 Install Manual page 3

Figure 2-1
ESD
ESD is a transfer of electrostatic charge between bodies of different electrostatic potentials,
such as an operator and a piece of electrical equipment. It occurs when electronic
components are improperly handled, and it can damage equipment and impair electrical
circuitry. Electrostatic discharge is more likely to occur with the combination of synthetic
fibers and dry atmosphere.
Always use the following ESD-prevention guidelines when removing and replacing
components:
•
Connect the chassis to earth ground with a wire that you provide.
•
Wear an ESD-preventive wrist strap that you provide, ensuring that it makes good skin
contact.
•
Do not touch any exposed contact pins or connector shells of uncabled router ports.
•
If cables are connected at one end only, do not touch the exposed pins at the unconnected
end of the cable.
Note
SELV Circuit Ports
H U B
E T H E R
N O H U
N E T
B
L IN K
C O N S O
L E
1 0 B A S
E T
This device is intended for use in residential and commercial environments only.
Includes
SELV circuits
C is c o 8
0 5
S E R IA L
Installing the Cisco 805 Router 2-3
ESD