Cas Remote - Nortel TFC002 Manual

Page 50 of 64 Implementation and operation

CAS Remote

Prompt Response
REQ NEW, CHG
TYPE CDB
CAS
CUST xx
ATDN nnnn
CAS (NO)YES
MAIN NO
DFLT (NO)YES
LDNT (NO)YES
LADN nnnn
RLA nnn
CHDN nnnn
HRCL 0-512
553-2681-100 Standard 5.00
To configure CAS Remote, respond to the prompts in the following overlays:
LD 15 – Add or change a CAS Remote for a customer.
Description
Add, or change the CAS Main.
Customer Data Block.
Release 21 gate opener.
Customer Number.
DN that must be dialed by local telephones to reach the
CAS Main attendant (default is 0).
(Do not) change CAS options.
This is a CAS Remote location.
System to recover in the active mode after sysload.
Special tone to be given to the CAS Main attendant on
presentation of LDN calls.
Local attendant DN (must be different from the DN entered
for ATDN.)
Route number for the Release Link Remote trunks.
DN to be dialed by the CAS attendant to place a call on
silent hold.
Time, in units of 2 seconds, that a call remains on silent hold
before being recalled to the attendant
Note 1: When the CAS feature is defined, a signal Remote key is
assigned automatically to the key above LPK5 on all CAS Main
Attendant Consoles.
Note 2: For the M1250 and M2250 Attendant Consoles, the C/H key
acts as the CAS key.
August 1996